Welcome to the best online Car Key information resource anywhere on the World Wide Web!

Remote Fob advice from AutoKey Squad Ford Car Key Specialist

Replace your Ford Car Keys DIRECT – Avoid Showroom Overheads

FORD PROGRAMMING PROCEDURES:

Fiesta 96, Puma (Infrared 2 Button)
Procedure
1. Turn Ignition switch to Position I and back to 0 as soon as the PATS LED
in the clock lights (The system is now ready for programming, to a maximum
time limit of 30 seconds)
2. Remove Key from Ignition, hold the FOB towards the Interior Light, and
press and hold the Single Arrow. Wait until the light on the Key flashes,
then press the Double Arrow 3 times., release the Single Button
3. Both LEDs (Key & Clock) should flash to acknowledge programming is
successful
4. To exit learn Mode, turn Ignition to II and then 0
5. A Maximum of 4 Remotes are possible
Mondeo 93> Mondeo 96> (Infrared 2 Button)
Procedure
1. Unlock Vehicle, and turn ignition to position 1.
2. Wait until the PATS LED illuminates (app 10 seconds)
3. Switch Ignition to 0 – within 5 seconds – LED will remain on
4. Point the Remote at one of the front Receivers
5. Press a button and keep pressed – within 20 seconds of step 3
6. When the LED on the Key lights press the other button 3-5 times
7. Release both buttons while still aiming at the receiver
8. If successful, both LED’s will flash 5 times
9. Repeat 5—9 for additional transmitters (within 30 seconds)
10 .When completed, Turn Ignition to II then 0 to store the Keys
Mondeo 98½> Scorpio 95> (Radio 3 Button):
Procedure
1. Turn Ignition 4 times from 0 to I, ending at position I. A tone should
sound.
2. Press the Remote Unlock button – another tone should sound.
3. Additional Remotes can be added by repeating Step 2, within ten seconds
of each remote.
4. To exit turn Ignition to 0 – another audible sound should be made.
1.4
KEY FOB PROGRAMMING
Fiesta 96> & Escort 98> (Radio 3 Button)
Procedure
1. Insert Key and turn to II, then Turn Key from II to I and back to II four
times within 3 seconds
2. The PATS LED should light. Turn Key to Position 0.
3. Press the Unlock button and keep it pressed until the PATS LED flashes
4 times.
4. Add additional fobs the same way. Turn to II and back to 0 to end.
Focus (Radio 3 Button)
Procedure
1. Switch Ignition On/Off (II/0) 4 times within 6 seconds until a sound is
made.
2. Press any button on Remote until a sound is made.
3. To program additional Remotes, repeat after 2 seconds after the sound.
4. Turn Ignition On/Off to exit.
5. A maximum of 4 remotes can be programmed.
Mondeo 96> Scorpio > 98 (Radio 2 Button)
Procedure
1. Turn Ignition to II, then turn ignition from II to I and back 4 times within 3
seconds.
2. The PATS LED on dash should light.
3. Turn Ignition to 0. Then press Unlock button and keep it pressed until the
PATS LED flashes 4 times (new fob first, then old)
4. Turn Ignition to II, then back to 0 to end.
1.5
KEY FOB PROGRAMMING
Cougar (Radio 3 Button)
Procedure
1. Turn Ignition On (II) and Off (0) 4 times within 6 seconds
2. With the Ignition at 0 the PATS LED should light continuously.
3. Press any button on the Radio Remote within 10 seconds
4. The LED should flash to acknowledge
5. Further Remotes (max. 4) can be added by pressing any button.
6. Program mode will end if Ignition turned on, or no new Remote Detected
within 10 seconds
NOTE : The first Cougars were 3 seconds instead of 6, and 20 seconds instead
of 10.
Transit (2000.5MY)
Procedure
1. Close all the doors.
2. Turn Ignition key from position 0 to II eight times within 10 seconds.
3. Make sure the vehicle locks and unlocks the doors.
4. Press the remote transmitter button within 20 seconds., and make sure
the vehicle locks and unlocks all the doors.
5. Up to 20 seconds is allowed to programme the next remote transmitter.
6. To programme additional remote transmitters, repeat steps 4 and 5.
7. Turn the ignition key to position 0 to exit the programming mode.
Note : Maximum 4 remote transmitters may be programmed.
Note : . Ensure the vehicle battery is fully charged and the anti-theft alarm
system is not armed or triggered.
Note : If programming ends with no new remote transmitters, the originals
are retained.
Note : The anti-theft alarm and double locking module will exit programming
mode automatically if four new remote transmitters have been programmed
or if no new remote transmitter has been programmed within the 20 second
programming mode.

That’s it you should be done! If that didn’t work, or your Ford remote fob is faulty, why not a get a competitive quote on a replacement for Ford Car Key Specialists AutoKey Squad?